I have a question about the "show fail" output below. Note that the secondary pix on which it was run shows "Active time" 4475970 seconds - about 52 days. But it shows the primary pix as "Active time 91301925 seconds - about 1056 days. How can there be this discrepancy in timeframes if they were originally deployed as a pair? Thanks.
To know the up-time (since last reboot) for a pix you must do a show version command on both units. The show failover command will display the time pix was running as the active unit. This counter only increase on the active unit.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...