Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Add New Pix-1fe

I need to add a new card to our pix 515e. I have a few questions before I start.

1. What are the steps I need to take. Like backup configuration, etc.

2. What steps to take after I bring the unit back on after I install the card.

Where can I get a detailed step by step intructions on the subject. I've been told that the pix needs to be powercycled twice for it to detect the card correctly.

2 REPLIES
Silver

Re: Add New Pix-1fe

It is always good to backup your configuration. A simple cut and paste into a notepad file should be good enough. Make sure you get a copy of the show version as well in that file.

The physical procedure is on this link:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_installation_guide_chapter09186a008017279d.html#wp1093647

Hope this helps.

Steve

New Member

Re: Add New Pix-1fe

Thank you for the quick responce. I would still like to get someones experience with this.

106
Views
3
Helpful
2
Replies
CreatePlease login to create content