Adding an ASA5520 to a VPN 3000 Concentrator Load Balance Setup
I have 2 VPN 3015 Concentrators running a Load Balance setup. I want to add a new ASA 5520 to the Load Balance Cluster. When I enable the ASA to participate it sees the master VPN 3015 and goes into a backup role but then looks to lose connection and revert to a master role. It continues to go back and forth. I never see the ASA under my VPN 3015 Load balancing Statistics. Not sure what I am missing. The ASA is in the same networks as the Concentrators for both private and public interfaces. Same virtual cluster IP, using the same UDP port, same IPSEC shared Secret. Any direction on troubleshooting this is appreciated.
Re: Adding an ASA5520 to a VPN 3000 Concentrator Load Balance Se
I have removed my 2 Concentrators and fired up my 2 ASAs. They are load balancing fine. i had planned on blending in one at a time but deciced to do the full cut and had no issues. thanks for the looks and the few replies
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...