Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Adding Routes to the PIX

Hello,

I have been told I need to add some routes to the PIX to allow some IP addresses to pass traffic. When I try to add the route the PIX says "cannot add route entry" Below is a sample route I am trying to add. Can anyone tell me what might be wrong?

route BiznezzINTF 2xx.1xx.1xx.xx 255.255.255.255 10.0.10.175

This is the exact command I am trying to enter (with a real public IP address of course. I know that much!)

All repliess will be rated.

2 REPLIES
Silver

Re: Adding Routes to the PIX

Are you trying to add route statements or static translation statements. A route statement tells the pix how to get to a specific network.

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727ab.html#wp1027614

If you are trying to allow specific inside addresses to be allowed outside you need to use access-list and NAT statements.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml

I've attached a few websites for each scenario to try to help you out. If you need more help please let me know.

Steve

Gold

Re: Adding Routes to the PIX

"route BiznezzINTF 2xx.1xx.1xx.xx 255.255.255.255 10.0.10.175"

verify the interface name BiznezzINTF. i was thinking the the 10.0.10.175 has to be on the same range of the pix connected interface, however, it's not the case as i tested it with both v6.x and v7. so the only thing i can think of is the interface name.

128
Views
0
Helpful
2
Replies