I have been provided with an ADSL connection to the internet. My company has had a Cisco 3600 router installed with a Radius router connected to the internet. I have just an ADSL modem and a win2k PC at home. To access the the VPN I have been told to dial 35 on a RAS connection and that somehow connects me to the network however this does not work. I am sure I need some sort of VPN software but my supplier says I do not. Any ideas ?.
You don't need any software if your company has paid a service provider/ISP or whoever you are dialinto to create a VPN from the access server you are dialing into across the internet to your 3600. However if this isn't something that has been provided or configured at your end and the service provider then you need a client initiated VPN, i.e. software client on your PC or router that creates a VPN session directly to the VPN termination point, i.e. your 3640.
Because you are using a 3600 running Cisco IOS you can only use the Cisco Secure VPN client 1.1 to create the VPN to the router, later in the year you will be able to use the VPN client 3.0 that is free to download from Cisco and ships with the VPN concentrator series at present.
You may be able to use your WIN2000 IPSec client to connect to the router but I can't remember if this works or not.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...