Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

After upgdate pix535 os ,pix Ignoring PCI card in slot 4

pix ignoring two pci card ,why ??

show ver list below :

Serial Number: 405300167 (0x182863c7)

Activation Key: 5f6dcede db39a37e bdd89444 a1142d0e

Do you want to enter a new activation key? [n]n

Writing 2494520 bytes image into flash...

1024MB RAM

Ignoring PCI card in slot:4 (vendor:0x8086 deviceid:0x1229 revisionid:0xc)

Ignoring PCI card in slot:5 (vendor:0x8086 deviceid:0x1229 revisionid:0xc)

Flash=i28F640J5 @ 0x300

BIOS Flash=DA28F320J5 @ 0xD8000

-----------------------------------------------------------------------

|| ||

|| ||

|||| ||||

..:||||||:..:||||||:..

c i s c o S y s t e m s

Private Internet eXchange

-----------------------------------------------------------------------

Cisco PIX Firewall

Cisco PIX Firewall Version 6.1(4)

Licensed Features:

Failover: Enabled

VPN-DES: Enabled

VPN-3DES: Disabled

Maximum Interfaces: 10

Cut-through Proxy: Enabled

Guards: Enabled

Websense: Enabled

Inside Hosts: Unlimited

Throughput: Unlimited

ISAKMP peers: Unlimited

Not enough supported network interface cards installed.

PIX requires at least 2 supported interface cards,

but only 0 supported interfaces were fou

  • Other Security Subjects
3 REPLIES
New Member

Re: After upgdate pix535 os ,pix Ignoring PCI card in slot 4

Hi there,

You will get more specific information from the console during boot. Try to capture that output and see if it gives you more specific information. Otherwise, you will need to look at what the cards are and perhaps what changes there may have been in the new release by looking at the release note to determine support ofr the cards. Let us know if this does not give you the answers...

Marcus

New Member

Re: After upgdate pix535 os ,pix Ignoring PCI card in slot 4

HI, perhaps I have foud the problem,that i82550 Ethernet controller chip cann't

work well on pix firewall,please visit bleow address,and check it is true or not,i would report this prolem to my customer.thanks!

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_field_notice09186a0080094509.shtml

New Member

Re: After upgdate pix535 os ,pix Ignoring PCI card in slot 4

I would say that this is the issue you are having if you do have the i82550 inteface card. As the advisory states, you will have to have the cards swapped directly from the TAC.

Marcus

202
Views
0
Helpful
3
Replies
This widget could not be displayed.