cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
334
Views
0
Helpful
1
Replies

After Upgrading PIX 515 Cannot access with Remote Desktop

lcoles
Level 1
Level 1

I recently upgraded my PIX 515 from 6.35 to 7.12. Before the upgrade I was able to remote desktop into my servers from home. After the upgrade when I try to connect it appears to be trying to connect. However, I get a message stating the network is broken and try again later. I didn't have to make any manual changes on my configuration, everything converted automatically to the new version. Has anyone had this problem? Thanks, Laurie

1 Reply 1

charles.diebold
Level 1
Level 1

You may try this and below is a link as well.

Check your logging on the pix and look for messages such as this:

4/7/2006 08:40 10.4.1.70 Warning Apr 07 2006 08:40:41: %PIX-4-419001: Dropping TCP packet from outside:68.15.199.241/80 to inside:66.70.69.249/55646, reason: MSS exceeded, MSS 1260, data 1452

I ran into something similiar with remote desktop it would attempt to connect and go to an hour glass and stop.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804c8b9f.shtml

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: