Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Aggressive Mode Configuration

In a VPN configuration I have a cisco 1700 router and on the other side I have a Firewall. I need to configure the Aggressive Mode that the firewall has already set on the router, so both devices can manage dinamic IP adresses from the ISP.

1 REPLY
Anonymous
N/A

Re: Aggressive Mode Configuration

To configure the Cisco VPN 500x to support LAN-to-LAN connections, it is necessary to define the tunnel configuration, as well as the IP communication parameters that are used in the tunnel. This is accomplished in two sections, the [Tunnel Partner VPN x] section, and the [IP VPN x] section. For any given site-to-site configuration, the (x) defined in these two sections must match, so that the tunnel configurations are properly associated with the protocol configuration.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2301/products_tech_note09186a00801e4db9.shtml

275
Views
0
Helpful
1
Replies
CreatePlease login to create content