Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Allow Netflow (Port 9996) thru PIX515E

Hello,

I have 2 routers on the outside of a 515e, I need to allow port 9996 for netflow through the firewall. However this just aint happening (Netflow is being exported) it just is not coming through the firewall.

Any ideas....anyone

R

Scott.

1 REPLY
New Member

Re: Allow Netflow (Port 9996) thru PIX515E

Hi Scott,

I'm not sure want you wanna do and where the pblm is located, but if you need to pass traffic from the outside to the inside intf of the pix, I'd suggest the following steps:

1)Add static for the inside host. (use IP that is routable for the routers)

2)Add access-list to permit tcp or udp traffic port 9996 to get thru the FW.

3)Bind access-list to the outside intf (access-group)

HTH

Mike

582
Views
0
Helpful
1
Replies
CreatePlease to create content