Anyconnect on our ASA is not logging sessions out. For instance, when i disconnect my session from my laptop, it still shows as a active session in ASA. This is eating up our licenses. Is there a setting i am missing?
You may try disconnecting from the AnyConnect Client Using PLAP - After successfully connecting the tunnel, the PLAP component returns to the original window, this time with a Disconnect button displayed in the lower-right corner of the window as shown in the below diagram:
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...