Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AnyConnect with ASA 8.02 not routing packets.

I have the Anyconnect client successfully working in the sense that I am able to login successfully, the AnyConnect client shows that I have an IP address from the range that I have setup, but I am unable to ping, telnet, surf the web etc.

Do I need to setup an additional static statement for the range of IP addresses I'm using? or use a nat 0 statement? I"m using a publicly routable block of IP addresses and if I do a 'show route' on the PIX I am able to see the IP address show up in the route table.

Any help or suggestions would be appreciated. Thanks!

1 REPLY
New Member

Re: AnyConnect with ASA 8.02 not routing packets.

BigPix# show vpn-sessiondb svc

Session Type: SVC

Username : denny Index : 7

Assigned IP : x.x.27.195 Public IP : y.y.y.y

Protocol : Clientless SSL-Tunnel DTLS-Tunnel

Encryption : RC4 AES128 Hashing : SHA1

Bytes Tx : 782727 Bytes Rx : 551731

Group Policy : DfltGrpPolicy Tunnel Group : DefaultWEBVPNGroup

Login Time : 11:38:50 EDT Fri Oct 5 2007

Duration : 0h:00m:10s

NAC Result : Unknown

VLAN Mapping : N/A VLAN : none

123
Views
0
Helpful
1
Replies