anyluck making vpn connections with cisco configmaker

[cshuker]

Certainly not for me anyway

I have tried and failed it creates the pretty diagram each router set to connect to the internet via ISDN and then the added VPN link connects the two routers but when the configs are delivered ,they dont work.

I am very new to Cisco but from what Ive seen ,their should be a tunnel interface created in the config, but this is not mentioned in the config created by config maker.

Can anybody offer a config for this setup?

I am trying to connect two private networks via a vpn over the public network. I have static public Ip addresses for each of the routers.

I have firewall and IPsec on the routers.

Have I missed anything I need

Thanks for any suggestions

Chris

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you.

I noticed another user offered some assistance on your other post at http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.ee71827

In any case, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

Thank you for posting.