I have 4 AP1042's, a 48 port SF 300 switch, and ASA 5505 that I'm trying to setup. I would love to have a public access, and private (LAN) access for WiFi. I'm not sure if it can be done with what I have on hand. I have the ASA handing out IP's via DHCP for just the native subnet but I need to break it up into at least to different subnets, one for the public and one for the private. How can I get this accomplished with what I have? Is it any way to Broadcast both the private and public SSID's on the 1042's? Any suggestion would be appreciated.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...