Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

As400 Keep Alive Command

I am looking for information about allowing 2 Cisco 2500 to allow Keep Alive calls from an AS400 to pass through each router.

Two Offices, 2500 at each office, AS400 located at one, both offices access the AS400 but the remote office periodically get dropped. Lines have been tested, IBM indicates that the routers are dropping or ignoring the Keep Alive command from the AS400.

Any suggestions?

Thank You,

Jake

  • Other Security Subjects
1 REPLY

Re: As400 Keep Alive Command

The topic of this forum is Virtual Private Networks however there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center http://www.cisco.com/tac or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

177
Views
0
Helpful
1
Replies