Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5500 U-turn

Hi,

I am trying to set up an ASA 5500 to do some routing. We have a couple of networks on the inside, and I am trying to use the router as the gateway address for one of them. It has routes to all the networks and I added the " same-security-traffic permit intra-interface" command gut that did not work. Am I missing something?

Thank you,

Joel Friedman

3 REPLIES
Hall of Fame Super Blue

Re: ASA 5500 U-turn

Joel

At the risk of stating the obvious, the interfaces do actually have the same security level ?

If so it could be a NAT issue - could you post config if at all possible.

Jon

New Member

Re: ASA 5500 U-turn

I am coming in and out of the same interface (inside). I am not sure if I can post the configuration, even sanitized, as it belongs to a customer of mine.

Joel

Green

Re: ASA 5500 U-turn

This should be one way to get it going...

security-traffic permit intra-interface

global (inside) 1 interface

nat (inside) 1 0 0

125
Views
0
Helpful
3
Replies