Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ASA 5510 + Failover Active/Standby

Hello,

i try to configure two ASA5510 in a failover szenario. After I have already finished the setup on the primary ASA I try to send the configuration to the secondary. Following Error is shown:

"Unable to configure the firewall at XXX.XXX.XXX.XXX for the following reason:

PDM was not able to determine the context mode of the peer at XXX.XXX.XXX.XXX"

Is this a problem of the context mode? Both ASA?s run in single mode or must there be a special Firewall configuration.

Thank you for your support.

4 REPLIES
Community Member

Re: ASA 5510 + Failover Active/Standby

Hi could you please tell me the physical connection of Fail over?

Community Member

Re: ASA 5510 + Failover Active/Standby

We have connected a crossover cable on the ethernet 0/3 in between both asa interfaces.

Community Member

Re: ASA 5510 + Failover Active/Standby

Can you send the show version output of the firewall?

check the failover license it has?

Community Member

Re: ASA 5510 + Failover Active/Standby

Licensed features for this platform:

Maximum Physical Interfaces : Unlimited

Maximum VLANs : 25

Inside Hosts : Unlimited

Failover : Active/Standby

VPN-DES : Enabled

VPN-3DES-AES : Enabled

Security Contexts : 0

GTP/GPRS : Disabled

VPN Peers : 250

WebVPN Peers : 2

This platform has an ASA 5510 Security Plus license.

They are identical on both ASAs.

325
Views
0
Helpful
4
Replies
CreatePlease to create content