Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5510 Firewal ACL HITCOUNT

I have a simple question but I am having a hard time getting an answer. WHen you do show access-list command on the ASA 5510 there is a hit count ....i know how to clear that but I want to knowis there a default timer that will clear the hit count ? Or does the hit count remain till I clear the count? I am trying to clean up some ACLs and for future troubleshooting I would like to know that. I dont want to remove an ACL entry with 0 hitcount and then it is needed.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ASA 5510 Firewal ACL HITCOUNT

The counters are there until one of two things happen; you clear them manually or you reboot the device. There are no timers to clear the counters. We usually clear the counters, let it run for a month or so then clean it up.

Hope that helps.

2 REPLIES

Re: ASA 5510 Firewal ACL HITCOUNT

The counters are there until one of two things happen; you clear them manually or you reboot the device. There are no timers to clear the counters. We usually clear the counters, let it run for a month or so then clean it up.

Hope that helps.

New Member

Re: ASA 5510 Firewal ACL HITCOUNT

Thanks thats great ...good ideal I just dont want to remove something and break it...

1501
Views
0
Helpful
2
Replies