Hi guys, I have a dmz network in the company I worked. A private network is connected to the DMZ interface of ASA 5510. I notices that every morning I have to issue the "clear xlate" command in the IOS so that computers can connect to the Internet.
Can you help me in fixing this guys? Please.... Thanks....
post the config please - could be the xlate timeout might be an issue, are you doing PAT or specific Interface NAT...you could be running out of slots (unlikely as there 65xxx) or IP addresses if you are doing 1 two 1 NAT!
Hi, I posted the config of our ASA 5510 here. Please kindly check on it. Just this morning I have to issue the "clear xlate" command again so I can access the Internet from the DMZ interface of the Firewall.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...