Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

asa 5510 remote access vpn - now need to add site to site vpn.

We currently have a remote access vpn setup and everything is workig fine.

I need to setup a lan-2-lan vpn now.

Can anyone point me to documentation on this ? i used the command line to add a site to site and it errored out and disconected me when i applied the crypto map to the outside interface. Do i need another crypto map or should i use my existing?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: asa 5510 remote access vpn - now need to add site to site vp

Shannon,

Please refer the below URL for configuration details. Eventhough the configuration is for Dynamic to Static IPSEC, you could use the concept to build the L2L Tunnel with Static IPs.

http://www.cisco.com/en/US/partner/products/ps6120/products_configuration_example09186a00805733df.shtml

Let me know if it helps.

Regards,

Arul

** Please rate all helpful posts **

1 REPLY
Cisco Employee

Re: asa 5510 remote access vpn - now need to add site to site vp

Shannon,

Please refer the below URL for configuration details. Eventhough the configuration is for Dynamic to Static IPSEC, you could use the concept to build the L2L Tunnel with Static IPs.

http://www.cisco.com/en/US/partner/products/ps6120/products_configuration_example09186a00805733df.shtml

Let me know if it helps.

Regards,

Arul

** Please rate all helpful posts **

215
Views
0
Helpful
1
Replies