Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5510 Remove VPN configuration

Hi

I am having some problems with the configuration af Remote VPN.

I have just received a new ASA 5510 and I have made the basic configurations so that I can browse the internet. I then went through the VPN Wizard and I can connect to the VPN without any problems but I can't connect to the internet through the VPN tunnel. I want all the traffic to pass through the VPN tunnel so no split tunnel.

Our configuration is:

Outside interface: Static public IP

Inside interface: 192.168.1.0

I am using the latest ASDM and ASA software.

As far as I am informed it should be possible to connect to the Outside interface through VPN and go back out to the internet through the same interface, but how do I configure it?

I have searched and searched and I can't find a solution to the problem.

Is there any special settings I need to be aware of?

/Lasse

1 REPLY
Bronze

Re: ASA 5510 Remove VPN configuration

This document describes how to set up a PIX Firewall 7.0.1 and later to perform IPsec on a stick. This setup applies to a specific case where the PIX does not allow split tunneling, and users connect directly to the PIX before they are permitted to go to the Internet.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805734ae.shtml

1391
Views
0
Helpful
1
Replies