Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5510 Security Plus - ACTIVE/ACTIVE not enabled

Hello,

I just checked one of our new ASA 5510 for the license that is configured on it. It shows a Security plus license but for some reason it shows 0 security contexts available (the device is just out of the box and is not configured yet) and there is no way to issue the command "mode multiple" either.

Looking at the Cisco documention I've seen that Security plus enables contexts....

Did anybody come across the same issue?

Regards.

2 REPLIES
Bronze

Re: ASA 5510 Security Plus - ACTIVE/ACTIVE not enabled

ASA 5505 Security Plus License with Failover and Dual-ISP Backup : This configuration creates five VLANs: inside, outside, dmz, backup-isp and faillink

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/examples.html#wp1038603

New Member

Re: ASA 5510 Security Plus - ACTIVE/ACTIVE not enabled

I believe you need to activate the license before the features are enabled. You should have received a PAK with the ASA. Usually it is a white envelope with a single sheet of paper in it. Go to http://www.cisco.com/go/license, enter the key there and you will receive a file via email that you upload to the ASA.

BTW ASA 5505 does not support contexts.

279
Views
0
Helpful
2
Replies