cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3187
Views
0
Helpful
2
Replies

ASA 5510 stuck on Launching bootloader

nitsaggy_hp
Level 1
Level 1

Hi,

We tried downgrading our ASA from 7.2 to 7.0.6. After uploading the image of 7.0.6 and putting the boot command, we reloaded the firewall.

ASA does not proceed after displaying "Launching Bootloader". It simply hangs on this message. We have to hardboot post this, and again it comes back on same message.

I uploaded the image again using TFTP from ROMMON, both to 7.0.6 and 7.2. It upgrades sucessfully, loads the ASA.

But as soon as you reboot, the ASA gets stuck again on "Launching bootloader".

Any help please...

2 Replies 2

srue
Level 7
Level 7

format your flash...

DO NOT REBOOT

then reload your image via tftp.

verify checksum then try to reboot.

So does the asa have nvram like a router? Where the hell is my config after I did this above it booted to a default config. If it does not have nvram, what a POS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card