Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5510 SVC Issues

Hi

I have implemented an ASA 5510 with a single subnet behind the firewall, 192.168.0.0/24

I have followed all the instructions in cisco documentation and I can connect no problems to the VPN. I am assigned an IP address from the dhcp server 192.168.0.100

However the only thing I can see (using ping is the default gateway - which happens to be the ASA internal interface192.168.0.1.

I am tunneling all traffic through the tunnel and local lan is disabled.

My only route on the firewall is 0.0.0.0 0.0.0.0 that points to our external router.

I have NO access rules or filters to prevent the traffic.

As I mentioned the only device I can see on the same subnet is the inside interface, any ideas as the routing on the internal subnet should already be known.

1 REPLY
Cisco Employee

Re: ASA 5510 SVC Issues

Without your configuration, I can't guess too much, but check your NAT acl to make sure that there is a nonat (nat 0) statement for your internal networks to your VPN pool.

--Jason

106
Views
0
Helpful
1
Replies