I am having a little issue I can't seem to get a grip on. I have our ASA IPSec VPN set and my end users can connect and authenticate just fine. My issue appears to be with routing. All servers are on the same network. I can ping a server at 192.168.1.50 but I cannot ping 192.168.1.51. All servers are set to use the same gateway. Also, if I log in to the 192.168.1.51 server, I can ping the remote client. So, I can ping out to the client on some servers but not in from the client. This is only on some servers, not all. The part that has me baffled is that these servers are on the same segment and all can ping the remote client. Any ideas? Thanks, Ken
We have discovered an IP addressing problem and have that resolved however I am having a new problem. If I ping from the remote host to the server I get no reply. If I ping from the server to the remote client I get success. From that point I can ping the server from the remote host. I have over 50 servers so I can't ping each remote host first. Any ideas why the client can't ping the server first?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...