Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5510 Write memory fails on all saves

Hi,

I've just obtained an ASA 5510 and everything was working fine as far as writing to memory as I was configuring it. Now when I go to save any changes at all I get Error - Invalid Input Detected.

Not sure if it's related, but when I go to "Tools- File management" The only thing listed under Disk0 is marker. I,nva,lid

Any ideas?

Thanks

4 REPLIES
New Member

Re: ASA 5510 Write memory fails on all saves

Try this:

1. check if Disk0 is accessible. dir disk0:

2. Save your config;

3. Disable logging from buffer to flash. no logg flash-buf

4. Run system check. fsck disk0:

5. Last step is to reformat Flash. format disk0:

New Member

Re: ASA 5510 Write memory fails on all saves

Hi & thanks,

I completed all these steps including reformatting drive0:

Then I ftp'd the asdm file back over.

I can see the files on drive0: fine through the CLI, but in asdm 5.0 under "File management" it's still not showing any files just invalid marker still.

Any further steps I can take.

Thanks!!

New Member

Re: ASA 5510 Write memory fails on all saves

Hold on a sec. Do You have this problem with ASDM only?

Try different/latest ASDM version.

New Member

Re: ASA 5510 Write memory fails on all saves

Thanks,

Now after upgrading via tftp and putting asdm 602 in disk0, when I run asdm launcher I get an error stating that it's unable to launch because I do not have the appropriate device manager installed. Asdm launcher supports asdm5.0 or higher versions only.

663
Views
0
Helpful
4
Replies