I am currently attempting to configure 2 VLANs on my ASA5520 and allow them to communication with my Catalyst 500 switch. The ASA Setup is fairly simple (to start) its 2 Sub-ints on the g0/0 interface. The Switch IP is 66.38.173.xxx 255.255.255.224
Int g0/0.1 Nameif outside66 ip: 66.38.173.xxx 255.255.255.224
Int g0/0.2 Nameif outside64 ip: 64.187.16.xxx 255.255.255.224
G0/0 Port on the ASA is connected to port 2 on my Catalyst. I set the Smartport on port 2 of the Catalyst to be Router for trunking purposes (I also tried Switch during testing). For some reason I cant ping from the ASA to the switch? I have also set up an access list to Allow ICMP Any any on the ASA.
I get a notification error on the Catalyst saying "Undersized frames detected from the connected device" (which is my ASA). This notification comes up each time I try to ping from the ASA to the Catalyst... does anyone have a suggestion? Or a link to sample config.
I get a notification error on the Catalyst saying "Undersized frames detected from the connected device" (which is my ASA). This happens when I attempt to ping from the ASA to the switch. I have re-done some config and set port 2 (connected to my ASAs g0/0 interface) as a router smart port (for trunking). I added Vlan 10 and 20 to the switch also. Anyone know what that notification means!?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...