Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5585 encountered a Failover

Ladies, Gentlemen

One of our security devices had encountered a failover,

Need an expert advise base from the Failover History what could be the issue.

Version: Ours 9.5(1), Mate 9.5(1)
Last Failover at: 15:50:05 SGT Jan 25 2016
This host: Primary - Standby Ready
Active time: 0 (sec)
slot 0: ASA5585-SSP-20 hw/sw rev (2.0/9.5(1)) status (Up Sys)
Interface mgmt0 (192.x.x.x): No Link (Not-Monitored)
Interface Production ASA (10.x.x.x): Normal (Monitored)
slot 1: empty
Other host: Secondary - Active
Active time: 69067 (sec)
slot 0: ASA5585-SSP-20 hw/sw rev (2.0/9.5(1)) status (Up Sys)
Interface mgmt0 (192.x.x): Normal (Not-Monitored)
Interface Production ASA (10.x.x.x): Normal (Monitored)
slot 1: empty

------------------ show failover history ------------------

==========================================================================
From State To State Reason
==========================================================================
15:50:14 SGT Jan 25 2016
Not Detected Negotiation No Error

15:50:31 SGT Jan 25 2016
Negotiation Cold Standby Detected an Active mate

15:50:33 SGT Jan 25 2016
Cold Standby Sync Config Detected an Active mate

15:50:44 SGT Jan 25 2016
Sync Config Sync File System Detected an Active mate

15:50:44 SGT Jan 25 2016
Sync File System Bulk Sync Detected an Active mate

15:51:00 SGT Jan 25 2016
Bulk Sync Standby Ready Detected an Active mate

15:51:08 SGT Jan 25 2016
Standby Ready Failed Interface check

15:51:16 SGT Jan 25 2016
Failed Standby Ready Interface check

31
Views
0
Helpful
0
Replies