Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA - Looking at ACL's (0xdec67386)

Hey guys, this may be a silly question but what are the HEX numbers after the ACL all about? Can you use them to tie the ACCESS list hit with the line in the ASA? That would be cool. Thanks.

access-list inside-in line 8 extended permit tcp any any eq www (hitcnt=176581) 0xdec67386

2 REPLIES
Silver

Re: ASA - Looking at ACL's (0xdec67386)

The general format is hostname(config)# access-list access_list_name [line line_number] [extended] {deny | permit} protocol source_address mask [operator port] dest_address mask [operator port | icmp_type] [inactive].There is no hexadecimal number in picture.Refer the following URL for more information on the access list

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a0080450bf0.html

Cisco Employee

Re: ASA - Looking at ACL's (0xdec67386)

Richard,

The hex number does not show up on 7.0. But, when I checked with 7.1 it does show up when you do a "show access-list". The interesting part is, the Hex number does not show up in the running configuration.

So, my guess is, the hex number is used to reference the access-list in memory. But, I dont see this documented anywhere in the Pix/ASA Documentation.

Having said that, I am not sure how much you could do with the Hex Number.

I hope it helps.

Regards,

Arul

237
Views
4
Helpful
2
Replies