Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA not failover

Hi Expert,

Need help.

Issue 1

When bring down ASA firewall Master unit, ASA secondary unit would not change to Active mode, it always in standby mode. This problem only can resolve when we manually change the secondary firewall to Active mode or unplug any cables from Master unit. Please advice this is hardware restriction or configuration issue?

Issue 2

Sometime, after do some changing in the ASA firewall, certain interfaces will no functioning for instance this firewall we used 5 interface, when we change or add one policy, _interface 0_ will stop functioning, even from firewall also cannot ping to other device go through this interface. This problem only can resolve after reboot ASA firewall.

Issue 3

Sometime, after change the policy, ASA firewall has few policies no functioning whereas the interface still running, it only infected certain server. This issue also needs to reboot firewall to resolve it.

May I know this firewall we cannot do configuration in peak hours? Or have any procedure we need to follow when we do the policy changing?

Please advise, thank you.

Rgds,

Au Yeong Shaw Voel

1 REPLY
New Member

Re: ASA not failover

Hi Everyone,

Can anyone please help?

Was my question too easy or too hard?

Please help.

Rgds,

Au Yeong Shaw Voel

96
Views
0
Helpful
1
Replies