Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA v7.2 "match header-flag" class-map subcommand

Hi,

could anyone running this version tell me what the cmd ref

means by:

match [not] header-flag [eq] {f_well_known | f_value}

eq Specifies an exact match. If not configured, specifies a match-all bit mask match.

I am not yet running 7.2 but I would like to know the syntax

of the bitmask and value.

Thanks a million

Jimmy Gauvin

PS Command comes from:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/m_711.htm#wp1743405

1 REPLY
Silver

Re: ASA v7.2 "match header-flag" class-map subcommand

To configure a match condition for a DNS header flag, use the match header-flag command in class-map or policy-map configuration mode. To remove a configured header flag, use the no form of this command.

match [not] header-flag [eq] {f_well_known | f_value}

no match [not] header-flag [eq] {f_well_known | f_value}

http://www.cisco.com/en/US/products/ps6120/products_command_reference_chapter09186a008063f573.html#wp1768996

165
Views
0
Helpful
1
Replies