Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA5505 A/S with ISP Failover

Hi Everybody,

I was wandering if it possible the deploiment shown in the figure below.

Proposal-BetaCap.png

The situation is:

Right now there is one ASA5505 that does Failover between the two ISPs using and SLA tracking.

I need add another ASA5505 in order to implement A/S failover for the Hardware but I'm not sure if the ISP failover is going to work witht the A/S deplyment.

Somebody could confirm if this scenario is valid??

Best Regards,

Jose

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

ASA5505 A/S with ISP Failover

Yes, i don't see a reason why it wouldn't work. It will continue to work with SLA tracking as there is only 1 active IP Address that the ASA uses, and the same ip address follows the active firewall.

3 REPLIES
Cisco Employee

ASA5505 A/S with ISP Failover

Yes, i don't see a reason why it wouldn't work. It will continue to work with SLA tracking as there is only 1 active IP Address that the ASA uses, and the same ip address follows the active firewall.

New Member

ASA5505 A/S with ISP Failover

thanks Jennifer,  One last question: Does the ASA5505 (Security Plus) support A/S High Availability???  Best Regards,  Jose

Cisco Employee

ASA5505 A/S with ISP Failover

No, A/S failover is not supported on ASA5505.

Here is the doc for your reference:

http://www.cisco.com/en/US/products/ps6120/prod_models_comparison.html

523
Views
0
Helpful
3
Replies
CreatePlease to create content