you dont need to configure any virtual MAC or IP address. once you configure failover, the box automatically replicates the MAC/IP from the primary to the failover. YOu just need to enable failover and configure failover IP addresses, which will be used to send keep alives.
you can have a look at this URL for getting to know more about failover in PIX or ASA
I had to put a mac address in that field for stateful failover to work. When I didnt do that, during a failover, the traffic stopped because the arp cache in the edge router was wrong. I had to clear arp for it to work. but when I put in the failover mac address entry all was well.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...