Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA5510 duplex mismatch

I have an ASA5510 (7.2(4)) with outside interface conn to ISP's Cisco 2610 (10M Ethernet - NOT FASTETHERNET).

Previously a PIX506E was attached to same router. PIX outside was set 'interface ethernet0 10full' and the router's E0/0 was hard set 'full-duplex'.

This link functioned as desired at 10/FULL.

Now when I conn the ASA I cannot get the link to come up at full-duplex. The 2610 is running c2600-i-mz.123-19 IOS.

Any suggestions from the Cisco community?

Phil

2 REPLIES
Gold

Re: ASA5510 duplex mismatch

hard code the asa to 10/full.

New Member

Re: ASA5510 duplex mismatch

I did - that's when the link will not establish.

224
Views
0
Helpful
2
Replies
CreatePlease login to create content