Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

asa5510 no site to site with watchguard

error message

Apr 02 18:52:19 [IKEv1]: Group = 219.240.18.2, IP = 219.240.18.2, Removing peer from peer table failed, no match!

Apr 02 18:52:19 [IKEv1]: Group = 219.240.18.2, IP = 219.240.18.2, Error: Unable to remove PeerTblEntry

1 REPLY
Bronze

Re: asa5510 no site to site with watchguard

It is quite impossible to help you when you're not giving a lot of information. I can point you in the right direction according to the error message, but it would be better if your post some more information te next time you have a problem.

You can find a step-by-step instruction for configurating a VPN Tunnel between a ASA and a Checkpoint Firewall. The configuration is almost the same for a ASA to a Watchguard!

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008009420f.shtml

Configuration Guides for the ASA can be found here:

http://www.cisco.com/en/US/products/ps6120/products_installation_and_configuration_guides_list.html

Loads of configuration examples for the ASA can be found here:

http://www.cisco.com/en/US/products/ps6120/prod_configuration_examples_list.html

Hope this information can help you solve your problem, it is very important to check your configuration twice for configuration-problems !

Please rate if the post helps!

Regards,

Michael

340
Views
0
Helpful
1
Replies
CreatePlease login to create content