Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA7.1 Allow traffic from 1 dmz server to Multiple Internal servers

I need to allow traffic from 1 dmz server to 4 other internal servers specific port traffic. When I try to add multiple statics to the same ip address(DMZSERVER)There is a conflict obviously. Is there away around this

dmz server 192.168.2.35

inside servers 172.18.20.2, 20.3 ,20.4 ,20.5.

  • Other Security Subjects
1 REPLY
Silver

Re: ASA7.1 Allow traffic from 1 dmz server to Multiple Internal

Each interface must have a security level from 0 (lowest) to 100 (highest). For example, you should assign your most secure network, such as the inside host network, to level 100. While the outside network connected to the Internet can be level 0. Other networks, such as DMZs can be in between. You can assign interfaces to the same security level. See the "Allowing Communication Between Interfaces on the Same Security Level" section for more information.

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008054c515.html

205
Views
0
Helpful
1
Replies