When I do changes in the security policies in the PIX using the ASDM, I apply and save. When I move from security policy interface to another one, e.g., NAT, I receive the pop-up message
There are changes to the configuration that have not been applied to the device.
Please apply or discard the changes before proceeding further.
I press apply and the pop-up disappears, then I try to move to the NAT interface and I get it again. It does not allow me to switch from the policy configuration screen unless I press ?disregard changes?
When I press ?disregard changes?, I switch between interfaces, luckily my changes I did are applied.
This is very annoying, and I wonder if this is a bug in the 5.21 ADSM
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...