Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASDM stuck in a loop at initlisation.

ASDM has been working fine, but has now decided to stop working. When I try to start it, it now goes into a loop showing 'Parsing Running Configuration', followed by 'Verifying Running Configuration', then back to the beginning again.

Any ideas?

ASDM 5.0(4), PIX 7.0(4).

1 REPLY
New Member

Re: ASDM stuck in a loop at initlisation.

I've resolved the issue by removing a NAT rule that applied explicitly to the workstation I was running ADSM from.

161
Views
0
Helpful
1
Replies