ASR - IPSEC, GRE, channel group, and MTU Questions
I have an ASR1004 and am trying to load-balance a 1.5G data rate over two 1-Gig ports using IPSEC ports, but I have a few questions.
1. Can GRE support a 9K mtu
2. Can you run IPSEC on a channel-group
3. Can the ASR load-balance per- S&D on a channel-group?
I currently have two separate tunnels, one on each outbound gig link with OSPF running. However, I can't get a 7000 mtu w/ the DF bit set through to the distant end. I am guessing this is because of the GRE interface.
So is it possible to run IPSEC on a channel-group and have this load balance per S&D? I need to use the BW of both ports.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...