Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Assign local Address to Dial-In User by Radius with Multilink

I am able to assign the address pool defined at the router to any dial-in user when i use normal ppp connections (ip:addr-pool=xxx at the radius server). When changing to ppp multilink the client gets no ip address assigned. Trying multilink:addr-pool=xxx as a Cisco-AVPair results in an error.

Any Help?

Thanks!

1 REPLY

Re: Assign local Address to Dial-In User by Radius with Multilin

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

92
Views
0
Helpful
1
Replies
CreatePlease to create content