Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

auto secure rollback

how do i rollback to the pre-autosecure configuration on the 1800 routers if the AUTO SECURE fails?

1 REPLY
Bronze

Re: auto secure rollback

In Cisco IOS Release 12.3(8)T, support for roll-back of the AutoSecure configuration is introduced. Roll-back enables a router to revert back to its preautosecure configuration state if the AutoSecure configuration fails.

System Logging Messages capture any changes or tampering of the AutoSecure configuration that were applied on the running configuration.

Note Prior to Cisco IOS Release 12.3(8)T, roll-back of the AutoSecure configuration is unavailable; thus, you should always save the running configuration before configuring AutoSecure.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hsec_r/sec_c1h.htm#wp1159652

253
Views
0
Helpful
1
Replies
CreatePlease to create content