I was upgrading 5 IDSs from version 3 to version 4 using the version 4 CD when one of them gave me the following message in RED on the bootom right corner of the screen after detecting the Keyboard and the CD drive.
The message :
Bad PBR signal no rom Basic system Halted...
I tried to restart a few times but it is alwayes teh same message
did anyone see this message before? Can any one help ?
It is more of a windows problem than a IDS problem. The message indicates that that no active partition has been defined in fdisk, hard disk drive not setup properly, or hard disk drive is bad. I'm not sure of the exact procedure but you will probably need to boot from a bootable diskette and enter fdisk.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...