Sorry for the most basic question here but this situation is this:
PIX 501 sitting between the Internet and LAN. This internet connection DOES NOT handle traffic initiated from within the LAN. I simply need to enable the PIX to accept incoming client connections. I've read through and tried varrious permutations as about 20 different Cisco documents. Each one simply is more complicated than I need. What do I need to do (probably an incedibly basic step I've missed) to tell the PIX to accept connections from incoming clients?
I've added the lines:
ip local pool inpool x.x.x.x-x.x.x.x
vpngroup vpn dns-server x.x.x.x
vpngroup vpn wins-server x.x.x.x
vpngroup vpn default-domian testdomain.com
vpngroup vpn password ********
sysopt connection permit-ipsec
no sysopt route dnat (I have no idea what this line means)
plus the basics, interface names, ip addresses, etc...
but to be completely honest the esaies way to do this is to upgrade the PIX to 6.2 and install a program called PDM 2.0 (PIX Device Manager) this new program has a wizard built in that allows you to create Site to Site or Software Client to PIX VPNs. It will configure the PIX to do what you want in a couple minutes. Its a very nice tool.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...