Hi there,I would like to install CiscoWorks, CSAMC (CSA Management Center) and CSM (Cisco Security Management) on the same server. Pls help to confirm if I can do it?!Thank you so much!
Hello Though this had happened to me once before, I haven't encountered this problem again until now. The agent installs apparently ok, reboots the workstation but upon restart it's not shown by the OS at the system tray and cannot be either reinstal...
The real question here is that since ISA doesn't use Syslog or SNMP as its standard communications protocol (it uses RPC), how will these devices integrate with MARS? Is a custom parser of any use here? If there is a solution, are there any caveat...
I have a CISCO 800 Series Router and here is the information about the ver filename "flash:c831-k9o3y6-mz.122-8.YN.bin". How can know which software to choose from so that I would have the most current version. I purchased the router in 2005.Thank yo...
Hello,I'm trying to understand the DVMPN Phase 3 and I'm trying get some clarification on the two commands:ip nhrp redirectip nhrp shortcutBased on what I have read (Shortcut Switching Enhancements for NHRP in DMVPN Networks) one thing i don't unders...
i am using MARS, and using IME (ips manager express) to monitor the network. i found that the alerts reporting from MARS are almost totally different from what the IME reporting. I thought they are using the same signature?? for example, IME reports ...
Hello! I have installed VMS with CSA 5.0 but the Cisco Security Agents database is too big, i have tried to shrink it from the management tab but it does not work, How can i manually compact this database?Regards
Dear allI have CSM 3.1 , I download the client from the server on a vista machine but it doesn't work. I tried with xp and it works fine.any help?Thanks on advance.
Hi ALL,We have two switches and TWo FWSM module is inserted into the Two switches .Can I add the FWSM as a separate device instead of module because i can't telnet the fwsm from Switch.Customer is not ready to configure the telnet option.FWSM module ...
Hello All,I have been tasked with configuring some port access for a server on my internal LAN. The Vendor provided me with 2 IP's on their end that I need to allow Port 1081 access to my server on my LAN.We use an ASA 5520(Ver.8.0) with ASDM 6.0(3)....
FWSM and IPS module is in the Core Switch.There is no telnet option from switch to FWSM and IPS module.So can i add the module as separate device...If add what are the changes to be done.
Hello what is the best practice for a security design, the use of independant switch for every DMZ or use a single core switch, with high performance and density of ports and i segment it with vlan for every dmz??? thank
