I’m having a hard time getting the securityk9 license to “activate”. I was under the impression that if you purchased a new router with the securityk9 license it would be preinstalled. I used the command “license right-to-use move securityk9”That cha...
Hi all.I want to get a monthly report of incoming emails and when I do it, it only gives me four days in the csv export file, is there a way to get the full report?
Is there a CVD for firewall HA/Cluster installations, ranging from smaller- to high-end appliances?
Good morning: We are trying to solve an issue with a vendor however for them to move forward they as asking for a PCAP that shows EAPoL occur. I have taken multiple pcaps and unable to find this within the PCAP. I have read other blogs/posts that...
Dear All,I am new here and this might make me posting this type of threat under the wrong location ... my apologies ...I passed CCIE written security exam and want to move on for CCIE Security lab exam as it is a precondition to book lab before 3 mon...
I need to put AntiSpoofing access-list on my boarder router. Can some one give me some examples?\Thanks
I have an ISE version 2.0.0.306, that I am trying to laod the certificate in to allow the web page to function that is displayed when guests try to utilize the Guest wireless, they put in their email address then I go in and authorize them and a temp...
I am looking to verify the integrity of a fresh router before being put into production. The documentation lists the following commands, but it doesn't mention how to actually verify the output - it just mentions comparing them to "Cisco-provided ref...
Hello everyone!Today I passed the test on my first attempt with a score of 898.The strategy followed was:1) Watch videos without pause twice.2) Watch videos again 2 times pausing, taking notes and screenshots.3) Read Cisco documents at-a-glance about...
We upgraded a pair of ISR4451 routers over the weekend to 16.6.6. They each have a port-channel connection to the core switch. When the routers came up after being rebooted they were not part of the port-channel. The channel-group command was no...
Hi,In Catalyst 2960 IOS version 12.2(58)SE there is a command "authentication open" when configure an interface, but in IOS version 12.2(46)SE I don't see this command.Can anybody give me this command or analog for this command for 12.2(46)SE?Thanks!
Correct Community Link: https://community.cisco.com/t5/security-documents/security-architectures-webinar-series-desert-plains-operation/ta-p/3889409
Hi All, I had recently implemented ACS 5.8.1.4 in my lab , have created user "xyz" with privledge level 15 in shell profile and permit all in command set. I have used TACACS+ protocol for AA although I am able to login to device with the created ...
Hello Everyone :)I recently got a cisco 3560 from cables and kits, and when I was looking at the port statistics I noticed that I had some Encap Failures. Ill post the info below: Also is this something that i should be worried about or is it normal?...
I used a rarely seen ssh client to connect to cisco's sshd service, sometimes it can be connected, sometimes not connected.Some rules are found by capturing packets. If the client sends its own version number after receiving the version number of the...
