Loopback 1 is on r3, and r4 do not have the net in the routing table anyhow, so I guess the config needs to be on r3,., I have never done this kind of config, so unsure of what to do. There are a pix between them
R3 Loopback 1 is : 10.10.11.11
R3 looback 0 is : 10.10.1.1
R4 loopback 0 is 10.10.2.2
There are ospf routes to pix, and static routes to r3 loopback0 on r4
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...