Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bi-Directional NAT on PIX

hi, I have following configuration on the pix 515

nameif ethernet0 outside security0

nameif ethernet1 inside security100

nameif ethernet2 test 75

nameif ethernet3 med security40

From med to test, we need set up the outside nat to nat the med's IP became one of the ip on test interface.

nat (med) 3 172.16.0.0 255.255.0.0 outside 0 0

global (test) 3 10.20.1.1

from inside to med there's no nat.

nat (inside) 0 0 0

when I set up the ouside nat, from inside interface I can not reach med interface any more. It showed "no translation group found..."

But from inside to med we already had nat (inside) 0 0 0 command.

Anybody can help?

Thx.

Yang

1 REPLY
New Member

Re: Bi-Directional NAT on PIX

Problem resolved.

Need a static command on the low security interface

static (med, inside) 172.16.0.0 172.16.0.0 netmask 255.255.0.0 0 0

93
Views
0
Helpful
1
Replies