Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Blocking timeout

Hi,

I use IDS v4 and blocking device is a Pix v6.2.

Is there a way to configure blocking period?

I can't find in current version blocking timeout.

And for specific signatures I think it should be perfect to be able to set this timeout.

Thank you.

  • Other Security Subjects
3 REPLIES
Cisco Employee

Re: Blocking timeout

You can configure the shun timeout value with the following CLI commands:

conf terminal

service virtual-sensor-configuration virtualSensor

tune-micro-engines

shunTime 15

You will be able to use IDM to configure the value in the 4.1 release.

New Member

Re: Blocking timeout

I found the setting under tune-micro-engines ->ShunEvent

It is planned to be a per signature setting?

Thank you

Cisco Employee

Re: Blocking timeout

No, the Shun Time is currently a global setting.

169
Views
0
Helpful
3
Replies