Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bridge Interfaces on Pix 515?

I do not believe I can do this, but need to ask anyway, I have a set of Pix 515e in Active/Standby, and will have a HA pair of Proxy Servers behind the Pix, directly connected. So I have 2 interfaces on each Pix Inside 2 Inside 3. Inside 2 goes to Proxy 1 and Inside 3 goes to Proxy 2. What you end up with is each proxy has a connection to each of the Pix, for a total of 4 connections.Ideally they would like to bridge Inside 2, to be on the same subnet and share an IP.

If that does not work, I thought I would just set them up as Inside 2 as 192.168.2.10, and then Inside 3 as 192.168.3.10. I would then put routing costs on Inside 2 and Inside 3, with Inside 2 as the main interface, and if it goes down, then try Inside 3.

Any help would be appreciated.

If

1 REPLY
Gold

Re: Bridge Interfaces on Pix 515?

please excuse me for misunderstanding. anyhow, pix doesn't permit two interfaces on the same subnet.

117
Views
0
Helpful
1
Replies