I got a serial interface as a member of bridge group 1. An IRB bridge with interface bvi 1 has been created. IPSec tunnel is supposed to between this serial interface and remote site. A crypto map has been configured under BVI 1 interface. However, we find that packets are decrypted in this router, but no packet is being encrypted from a command "show crypto engine connection active", there is no increase in Encrypt column.
May I ask is it feasible to implement crypto map in BVI interface. And is there any alternative for this case?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...