We have two CAM appliances and they are configured in HA mode. Today i have noticed that one of them is active and the other one is dead and I can't access it by using web admin console although i can access it by CLI and I can ping the active one from it and also ping the failover IP. What is the reason of the following error message? why couldn't I access its web admin console?
Service Temporarily Unavailable
The server is temporarily unable to service your request due to maintenance downtime or capacity problems. Please try again later.
The failover interfaces are UP-UP on the two switches that are connected to the CAM appliances. please find below the status of the two failover interfaces on both appliance as they can't ping each other:
That's what I was asking, the version. So 4.7.1 with HA broken. No easy fix.
Log on to the one that seems to be dead. Stop perfigo service, and remove these files: /etc/ha.d/perfigo.conf, /etc/ha.d/haresources, /etc/ha.d/ha.cf
Reboot the CAM, and when it comes back up, it will be in standalone mode. Reconfigure the HA on it. Make SURE that your certificates are set right on both boxes, otherwise HA will fail again or not work right at all.
If all else fails, open a TAC case so an engineer can work with you.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR
and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity
options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in
HA DocumentationCode download linksGoalRequirementLimitationsSupported
ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationCo...
Question I am currently unable to specify "crypto keyring" command when
configuring VPN connection on my cisco 2901 router. The following
licenses have been activated on my router :